Security Link SL150 Instrukcja Naprawy Pobierz pdf (Strona 95)

Section 17 -Output Device Programming

17–3

If a relay is energized before a 4-wire smoke detector is reset, the relay will be stopped by the

interruption of Aux.

Power that resets the smoke detector. If this is not desired, supply power to

the relay unit from another 12V power source (e.g., the same source that is powering external

equipment through the relay contacts).

Programming Output Relays and Powerline Carrier Devices

While in Program mode, press ✱

80 to enter Output Device Menu mode. This mode is

used to program all output devices used in the system (Error! Bookmark not defined.4229

or Error! Bookmark not defined.4204 Relay Modules, or Powerline Carrier devices). Refer

to the Output Device Table for

✱

80 in the separate “Programming Guide” form when

programming Output Devices.

NOTE: If you are using Powerline Carrier devices, the House ID of the devices must be

entered in data field

✱27.

After you key in

✱80, the following prompts are displayed.

Output Device Displays

Enter Device No.

(00 = Quit) 01

Enter the Device Number

for a 4229; or

, or

for a 4204; or

–

for Powerline Carrier devices; or

to end

these entries. Press

✱

to continue.

The

✱

key is used to accept an entry and advance to the next

prompt. The # key is used to revert back to the last question to

check or change an entry. Press

✱

to go forward again.

02 A EV ZL ZT

STT 0 0 0 00

This screen displays a summary of the current Device START

programming (for this example, device 02 has been selected).

Press

✱

to continue.

02 A EV ZL ZT

STP – – 0 00

This screen displays a summary of the current Device STOP

programming.

Press

✱

to continue.

02 Device Action

No Response 0

Enter the desired device action as listed below. Press

✱

to continue.

0 = No response 2 = Close and Stay Closed

1 = Close for 2 seconds 3 = Continuous Pulse on & off

(

1 sec ON,

1 sec OFF)

02 Start Event

Not Used 0

Enter the event to

start

the relay:

0 = Not used; 2 = Fault; 1 = Alarm; 3 = Trouble

A zone list must be used in conjunction with an event. If a zone

type/system operation is to be used instead of an event, enter

Press

✱

to continue.

02 Start: Zn List

No List 0

If a zone list will be used to

start

the relay action, enter the zone

list number (to be programmed in field

✱

81):

, or

. If not used,

enter

. Press

✱

to continue.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 143 144

Komentarze do niniejszej Instrukcji

Brak uwag

Security Link SL150 Instrukcja Naprawy Strona 95

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Security Link SL150